A dealer and some locksmiths can do that, and there is some software/device you can buy on eBay/Amazon to do this. When you replaced the ignition switch, did you also replace the immobilizer unit next to the switch? Because it seems as if the immobilizer is not recognizing the keys. Please check this out and try to describe the issue better.

To deactivate the immobilizer system: Insert the ignition key into the key cylinder and turn it to the ON position. To activate the immobilizer system: Turn the ignition key to the OFF position. The immobilizer system activates automatically. Without a valid ignition key for your vehicle, the engine will not start. WARNING.

code 81 "immobilizer control unit- circuit fault". and. Immobilizer Red Light. code 14: "malfunction in transponder of black ignition key". Also, the Supermoto is a little different from the Adventure in that there are no wires (immobilizer pick up)on the black plastic ignition barrel cover.
If your Toyota has an immobilizer system, you’ll need to follow a few steps to deactivate it before you can sell the car. Here’s what you need to do: 1. Find the immobilizer box. It’s usually located under the dashboard, near the steering column. 2. Locate the two wires that are connected to the box.
Open the vehicle mechanically with the key. Press the unlock button of the remote control key. Insert the key into the ignition switch and switch to the ON position. Switch the key OFF again and remove the key. Press the unlock button or the locking button of the remote control key.
5.7. HemiLonestar said: You'd have to remove the SKIM (Sentry Key Immobilizer Module) from the column and REPLACE (not reprogram) your PCM. ****** PCM's can be put anywhere but once a PCM gets a SKIM initialized to it, it's a SKIM PCM from then on out.
If the immobilizer is activated but shouldn’t, you can reset it by disconnecting power to the Engine Control Module. Look at the fuse box in the engine bay or the side of the dashboard. Find the fuse that says Engine Control Module (ECM) and unplug it for at least 5 min. Reconnect it and try to start the engine.
ikAMS.
  • 64fd0ofcz3.pages.dev/16
  • 64fd0ofcz3.pages.dev/319
  • 64fd0ofcz3.pages.dev/301
  • 64fd0ofcz3.pages.dev/981
  • 64fd0ofcz3.pages.dev/60
  • 64fd0ofcz3.pages.dev/719
  • 64fd0ofcz3.pages.dev/136
  • 64fd0ofcz3.pages.dev/69
  • 64fd0ofcz3.pages.dev/760

    • how do i disable immobilizer